Installation
Remove all packing materials from the EM-7.3. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Functions
1. MIC
Electronically balanced XLR-type input for connecting low
impedance microphones. The input has extremely low noise
and low hum. When connecting a microphone make sure
that the pin assignment is correct. Always make sure to read
the manual of the microphone you want to connect. The
XLR- input is not suitable for connecting an additional mixing
console, FX- unit, etc. You have to use the Line- inputs, when
connecting this kind of equipment.
Note: When connecting signal sources, please make sure
that the corresponding channel faders and the master
Fig. 3 faders are at their minimum settings. Otherwise unpleasant
plug-in noise can occure.
2. Zone select
Use these 3 switches to assign the channel to 1 or more master outputs.
3. Overload Indicator
The overload indicator shows peak levels in a channel’s incoming signal level. If the red overload LED
frequently blinks or constantly lights, the corresponding channel is likely to enter clipping and you have to
reduce the input’s amplification using the level control. The overload LED lights at a level of 8 dB below
clipping. Make sure that the overload LED lights only briefly during dynamic peaks.
4 / 5 / 6. Equalizer SECTION (HI / MID / LOW)
The mixer’s Equalizer section allows shaping of the incoming audio signal. All mono input channels are
fitted with 3-band EQ. The Hi (6) and Low (4) shelving controls have their frequencies fixed at 12KHz and
80Hz respectively. The Mid (5) range control has a peaking response frequency at 2.5KHz. All 3 bands
have up to 12dB cut and boost, with a centre detent. Turning an Equalizer control to the right amplifies
the frequency range, turning to the left attenuates the signal. Minor changes to the Equalizer control
usually produce the best results. Try to avoid excessive enhancement of the MID band.
7. Talkover On Switch
Use this switch to activate the talkover function.
8.Power LED
The red power LED lights when the Sessionmix is turned on. If after switching the device on, the LED does
not light, make sure that the AC adapter is connected properly. If the LED still doesn’t light up after
everything is connected right, please contact your DAP audio.
9. MIC Level (Mic 1/2)
Controls the volume of the Microphone channel.
10. Talkover Amount Control
Use this control to set the amount of signal reduction for the line channels 1-5 when spoken in the
microphone.
11. Talkover Time Control
This control allows you to set the time for returning to the normal volume level of the line channels 1-5 if
you stop speaking in the microphone.
(33 paginas)
(20 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales